[Instruction]The flashing method of the Moto C plus with PC via FlashTool

[Arjun_Rishi 17]

[Instruction]The flashing method of the Moto C plus with PC via FlashTool

 

Before flashing:
1- Charge the unit to more than 25%
2- If you have entered a google account, go to settings-accounts- google- delete, then Settings-recovery and reset reset settings. All DATA will be erased after update!
3- Use ONLY the version of the firmware embedded in the firmware and the recommended Download agent
4- check the machine version:
A) 1 GB of RAM or 2 Gb of RAM! Firmware is NOT compatible!
5- Install the MTK driver firstly!

method of update:
1- unpack the archive with the firmware and check that when unpacking there are no errors, ie the file is downloaded correctly and completely.
2- Prepare the machine.
3- open the folder from your PC - Download_tool
4- Start the flash_tool- flash_tool.exe
5- Open the settings of the Tool- as on the picture below

6- Check the following settings sections: Download - USB checksum / Storage checksum and close the settings

7- Select the file in the folder with the firmware: MT6737M_Android_scatter.txt

8- Select Download -Agent (located in the tool FOLDER) MTK_AllInOne_DA.bin

9- Select Authentication file (located in the Tool FOLDER) auth_sv5.auth

10- Selecting the flashing mode- Dowload Only

10- check all the parameters-as in the picture below and immediately click the DOWNLOAD button

11- take the smartphone, pull out the battery, insert the battery, close the back cover, hold down the VOLUME MINUS button and insert the USB cable
12- If the driversis installed correctly and you have done everything right, let's go through the firmware-

13-the end of the firmware-press OK and turn on the device LONG by pressing POWER (VERY long)

 

Choose the region code :
After the machine has started, enter anything on the welcome wizard - it does not matter
open the dialer (phone) and enter: #### 682 #

wait. a window with a region selection appears, select the desired one and press OK. The device will reboot after 1-2 minutes, reset the settings again and apply the region
If you have a window with an error, the region is already installed and can not be changed.